Dell Poweredge

  • Subscribe to our RSS feed.
  • Twitter
  • StumbleUpon
  • Reddit
  • Facebook
  • Digg

Wednesday, February 2, 2011

Dell Poweredge 2950 Failure

Posted on 7:35 AM by Unknown
Server failure
This server failed with the error "E171F PCIE Fatal Err B0 D3 F0" during power up. Upon inspection it was found that the 5/I PCIe SAS Controller card model no UCS-51 had a swollen electrolytic capacitor. This was replaced with one from an old PC motherboard, it had the same value (1500uF) and voltage rating (6.3v). After replacement the server booted and completed all it POST and began booting the OS. The server was soak tested and appeared to be operating fine. Hopefully saved an engineer call-out that probably would cost ~£500. By the way the machine was out of warranty. Below are pictures of the board and the repair.

Swollen Capacitor

Capacitor Repair
Supplemental Info A further 5 Dell servers came up with the same error and these were fixed by replacing the capacitors, bad batch of electrolytics.
Read More
Posted in | No comments
Newer Posts Older Posts Home
Subscribe to: Posts (Atom)

Popular Posts

  • Using a clone image on new hardware.
    The Centos networking will not work after the new hardware is using a clone image. The problem occurs because the MAC addresses on the new h...
  • OpenWRT MR3220 Command Snippets
    Reset the OpenWRT on Router back to the default use the command mtd -r erase rootfs_data Turn Wifi off uci set wireless.@wifi-device[0].dis...
  • SSH Tunnel Example
    Tunnel ssh from Local Machine to Remote Machine and from Remote Machine to a Local Machine on Remote Machines network. Local to remote machi...
  • PXE Boot a Dban image from an Ubuntu Server
     Dhcp Offers from Ubuntu Server to Compute Nodes ****Note**** exercise extreme care with these notes I have made as you can boot and wipe an...
  • Setting up Open-SSH in Ubuntu
    OpenSSH I set-up Open-SSH by installing the package ssh using the command 'sudo apt-get -y install ssh' . I then edited the config f...
  • 1Password using Wine in Ubuntu
    This program would not run properly in Ubuntu 10.10 it would not allow the creation of a 1Password folder but installing DirectX9 seems to h...
  • MR3220 OpenWRT Extroot installation
    The TP-Link has OpenWRT installed using either tftp or via the serial port using Kermit. Install the packages for using USB as storage on O...
  • Wine Install IE7 Problems
    Info from Wine HQ App Testing Info To install use the commands below : Install with "export WINEPREFIX=~/.wine_ie7" then "win...
  • SSH Tunnel command
    Command to setup the tunnel ssh -N -p 11000 remoteuser@remotecomputer.net -L 5901/localhost/5900 To view from Local computer vncviewer 127.0...
  • Getting the Arnova 9 G2 into Recovery Mode
    To enter Arnova 9 G2 recovery mode, press the esc button then using a paperclip press the recessed reset button (its located on the top edge...

Categories

  • Cluster Login Problem
  • Hadoop Cluster Passwordless SSH login
  • Open-SSH Installation
  • Software Update Command Line

Blog Archive

  • ►  2013 (6)
    • ►  September (3)
    • ►  April (2)
    • ►  March (1)
  • ►  2012 (16)
    • ►  November (1)
    • ►  October (1)
    • ►  July (2)
    • ►  June (3)
    • ►  May (1)
    • ►  April (1)
    • ►  March (3)
    • ►  February (3)
    • ►  January (1)
  • ▼  2011 (17)
    • ►  December (1)
    • ►  November (3)
    • ►  August (4)
    • ►  July (1)
    • ►  June (2)
    • ►  May (2)
    • ►  March (2)
    • ▼  February (1)
      • Dell Poweredge 2950 Failure
    • ►  January (1)
  • ►  2010 (18)
    • ►  December (2)
    • ►  September (2)
    • ►  August (2)
    • ►  July (4)
    • ►  June (7)
    • ►  May (1)
Powered by Blogger.

About Me

Unknown
View my complete profile