Dell Poweredge

  • Subscribe to our RSS feed.
  • Twitter
  • StumbleUpon
  • Reddit
  • Facebook
  • Digg

Thursday, April 4, 2013

Raspberry PI Enterprise Wifi

Posted on 7:33 AM by Unknown
The dongle I used was the Farnell WiPi this was identified by the PI using
the command lsusb as a
Bus 001 Device 005: ID 148f:5370 Ralink Technology, Corp. RT5370 Wireless Adapter

I put the required certificate in the /etc/cert directory.
The wpa_supplicant.conf file was edited as follows:-
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
ctrl_interface_group=root
update_config=1
network={
ssid="myAP"
key_mgmt=WPA-EAP
eap=PEAP
identity="myuser"
password="mypassword"
ca_cert="/etc/cert/cacert.crt"
phase2="auth=MSCHAPV2"
priority=0
}

The file /etc/network/interfaces was edited as follows :-
auto lo
iface lo inet loopback
iface eth0 inet dhcp
allow-hotplug wlan0
iface wlan0 inet manual
wpa-roam /etc/wpa_supplicant.conf
iface default inet dhcp
gateway 192.168.1.1
up route add default gw 192.168.1.1

Email ThisBlogThis!Share to XShare to FacebookShare to Pinterest
Posted in | No comments
Newer Post Older Post Home

0 comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Popular Posts

  • Using a clone image on new hardware.
    The Centos networking will not work after the new hardware is using a clone image. The problem occurs because the MAC addresses on the new h...
  • OpenWRT MR3220 Command Snippets
    Reset the OpenWRT on Router back to the default use the command mtd -r erase rootfs_data Turn Wifi off uci set wireless.@wifi-device[0].dis...
  • SSH Tunnel Example
    Tunnel ssh from Local Machine to Remote Machine and from Remote Machine to a Local Machine on Remote Machines network. Local to remote machi...
  • PXE Boot a Dban image from an Ubuntu Server
     Dhcp Offers from Ubuntu Server to Compute Nodes ****Note**** exercise extreme care with these notes I have made as you can boot and wipe an...
  • Setting up Open-SSH in Ubuntu
    OpenSSH I set-up Open-SSH by installing the package ssh using the command 'sudo apt-get -y install ssh' . I then edited the config f...
  • 1Password using Wine in Ubuntu
    This program would not run properly in Ubuntu 10.10 it would not allow the creation of a 1Password folder but installing DirectX9 seems to h...
  • MR3220 OpenWRT Extroot installation
    The TP-Link has OpenWRT installed using either tftp or via the serial port using Kermit. Install the packages for using USB as storage on O...
  • Wine Install IE7 Problems
    Info from Wine HQ App Testing Info To install use the commands below : Install with "export WINEPREFIX=~/.wine_ie7" then "win...
  • SSH Tunnel command
    Command to setup the tunnel ssh -N -p 11000 remoteuser@remotecomputer.net -L 5901/localhost/5900 To view from Local computer vncviewer 127.0...
  • Getting the Arnova 9 G2 into Recovery Mode
    To enter Arnova 9 G2 recovery mode, press the esc button then using a paperclip press the recessed reset button (its located on the top edge...

Categories

  • Cluster Login Problem
  • Hadoop Cluster Passwordless SSH login
  • Open-SSH Installation
  • Software Update Command Line

Blog Archive

  • ▼  2013 (6)
    • ►  September (3)
    • ▼  April (2)
      • Raspberry PI Enterprise Wifi
      • Raspberry PI Kiosk
    • ►  March (1)
  • ►  2012 (16)
    • ►  November (1)
    • ►  October (1)
    • ►  July (2)
    • ►  June (3)
    • ►  May (1)
    • ►  April (1)
    • ►  March (3)
    • ►  February (3)
    • ►  January (1)
  • ►  2011 (17)
    • ►  December (1)
    • ►  November (3)
    • ►  August (4)
    • ►  July (1)
    • ►  June (2)
    • ►  May (2)
    • ►  March (2)
    • ►  February (1)
    • ►  January (1)
  • ►  2010 (18)
    • ►  December (2)
    • ►  September (2)
    • ►  August (2)
    • ►  July (4)
    • ►  June (7)
    • ►  May (1)
Powered by Blogger.

About Me

Unknown
View my complete profile